top of page
Cannot see the Listo Internet Setup Network

If you are commissioning a Listo EMS and the 'Listo Internet Setup' network cannot be found while searching for networks on your phone, tablet or computer, follow these steps.
Check EMS Controller Status.
Ensure the EMS controller is plugged in and powered. Check the LED status:
Single or 3x Pulsing Green - proceed to step 2.
Solid Red - You have successfully connected the EMS controller to the internet, please return to app.unicopower.com/listo-setup to complete installation.
Flashing Red - The Listo EMS controller was previously connected to the internet and has become disconnected, please confirm the home Wi-Fi is active at the EMS controller.
Single/3x Pulsing Green LED
If the LED is single or 3x pulsing green and the 'Listo Internet Setup' network is NOT available, please power cycle the EMS controller and wait up to 3 minutes for the LED to start 3x pulsing green. If the setup network becomes available, go to https://192.168.42.1 to complete Wi-Fi setup. If the LED is stuck single pulsing green after multiple power cycles, proceed to step 3.
Connect to Ethernet
Obtain a cat6 patch cable and phillips head screwdriver. Unplug the CTs and unscrew the Listo EMS controller from the wall. Gently unscrew the top screws from each side of the Listo Controller (pictured).


Carefully remove the top of the device, resting it on a flat surface (pictured).


Connect the cat6 cable to ethernet port on the board(pictured). Leave it plugged in until the status light goes to solid green (EVSE and Internet connected) or solid red (Internet connected, EVSE disconnected). Leave the EMS controller plugged in for 5 minutes so it can update. After 5 minutes, disconnect the ethernet cable and reconnect the top casing of the controller.

Reconnect the CTs and mount the controller on the wall. Power the EMS controller and wait until the LED starts 3x pulsing green. Now the Listo Internet Setup network should be available on your phone or computer. Connect to this network and go to https://192.168.42.1 to complete Wi-Fi setup.
bottom of page